Loading... Please wait...

Add to Wish List

Click the button below to add the Victron Energy Smart Battery Monitor with Blue Tooth to your wish list.

You Recently Viewed...

Our Newsletter


Victron Energy Smart Battery Monitor with Blue Tooth

RRP:
$299.00
Your Price:
$274.00 (You save $25.00)
SKU:
VICTRON BATTERY MONITOR SMART SHUNT
Weight:
2.00 LBS
Availability:
YES
Shipping:
Calculated at checkout


Product Description

With Bluetooth built-in, the BMV Smart is ready for the Internet of Things (IoT) era. With Bluetooth being implemented in most other Victron Energy products, wireless communication between products will simplify system installation and enhance performance.

victron-battery-monitor-300.png

Easy to installAll electrical connections are to the quick connect PCB on the current shunt. The shunt connects to the monitor with a standard RJ12 telephone cable. Included: RJ 12 cable (10 m) and battery cable with fuse (2 m); no other components needed.Also included are a separate front bezel for a square or round display appearance, a securing ring for rear mounting and screws for front mounting.

Midpoint voltagemonitoringOne bad cell or one bad battery can destroy a large, expensive battery bank. When batteries are connected in series, a timely warning can be generated by measuring the midpoint voltage. Please see the BMV manual, section 5.2, for more information.

victron-smartshunt-500a-50mv-300.png

The SmartShunt is an all in one battery monitor, only without a display. Your phone acts as the display. The SmartShunt connects via Bluetooth to the VictronConnect App on your phone (or tablet) and you can conveniently read out all monitored battery parameters, like state of charge, time to go, historical information and much more.

Alternatively the SmartShunt can be connected and be read by a GX device. Connection to the SmartShunt is made via a VE.Direct cable.

The SmartShunt is a good alternative for a BMV battery monitor, especially for systems where battery monitoring is needed but less wiring and clutter is wanted.
The SmartShunt is equipped with Bluetooth, a VE.Direct port and a connection that can be used for: monitoring a second battery, midpoint monitoring or a temperature sensor.

victron-energy-blue-tooth-display-300.png

Very low current draw from the batteryCurrent consumption: 0,7Ah per month (1mA) @12V and 0,6Ah per month (0,8mA) @ 24VEspecially Li-ion batteries have virtually no capacity left when discharged until low voltage shutdown.After shutdown due to low cell voltage, the capacity reserve of a Li-ion battery is approximately 1Ah per 100Ah battery capacity. The battery will be damaged if the remaining capacity reserve is drawn from the battery. A residual current of 10mA for example may damage a 200Ah battery if the system is left in discharged state during more than 8 days.  

Bi-stablealarm relayPrevents increased current draw in case of an alarm.  

Otherfeatures- Battery voltage, current, power, ampere-hours consumed and state of charge- Remaining time at the current rate of discharge- Programmable visual and audible alarm- Programmable relay, to turn off non critical loads or to run a generator when needed- 500 Amp quick connect shunt and connection kit- Shunt selection capability up to 10.000 Amps- VE.Direct communication port- Stores a wide range of historical events, which can be used to evaluate usage patterns and battery health- Wide input voltage range: 6,5 – 70V - High current measurement resolution: 10 mA (0,01A)- Additional input to measure voltage (of a second battery), temperature or midpoint voltage, and corresponding alarm and relay settings.

DATA SHEET

victron-energy-smart-battery-monitor-with-bluetooth-wegosolar.jpg


Find Similar Products by Category